Complaint 2004289

Complaint Summary

POWER TRAIN

Owner Narrative

Upon starting the trucks engine, putting the transmission in gear (either Reverse or Drive), at idle engine speed (approx 700-800 rpm) or very low (near idle speed) the trucks engine starts to surge from idle then drops down to 500 rpms with a voltage drop (5V) too. It will do this a couple of times and then the trucks engine dies (engine stops) while in gear and no codes are shown on the CEL or saved in the vehicle control module. When I put the transmission in Park, the trucks engine restarts without a problem. But when I go to Drive or Reverse gear it then will do it again. The truck sounds like the engine brake is being applied causing the engine to lug/bog down. The torque converter has been inspected and replaced. The fuel pump/lifter has been replaced. The batteries have been replaced. The fuel filters have been serviced; the crank case breather has been serviced. The emissions controls equipment (EGR valve) have been serviced/cleaned. Knowing that my trucks engine can cut out/die at anytime at low rpms, poses a safety hazard. Knowing that the truck can do this without a code being throw feels unsafe.

Owner-submitted narrative on file with NHTSA. Complaint narratives are self-reported and have not been verified.